Difference between revisions of "Set up the miniSim"

Revision as of 16:21, 26 January 2015

The miniSim is a PC-based research driving simulator that provides a realistic automotive driving environment. The system consists of a single PC for simplicity and reliability, three front channel displays, an instrument panel display, USB steering wheel and pedals, 2.1 audio system, a tactile transducer, and a display for the operator/instructor.

Place the Steering Wheel and Pedals

Unpack the steering wheel and pedals. Plug in the power supply, pedal, and shifter cables to the underside of the ECCI or G27 wheel per the manufacturer’s instructions, Figure 3. Fasten the wheel and shifter to the desktop following the manufacturer’s instructions, and place the pedals on the floor under the table, Figure 4.

Place the Instrument Panel Display

CAUTION! Please read the warnings and handling instructions for the LCD displays located in the appendix.

The Instrument Panel LCD attaches to an aluminum bracket that holds the display at a 45 degree angle, Figure 5. Mount the display to the bracket using the supplied thumb screws, being sure the display is upside down, Figure 6. Connect the power and VGA/DVI cable to the display. Place the display on the table directly behind the steering wheel, Figure 7.

In the case of the 3-channel setup with 20” LCDs, attach the LCD to the instrument panel bracket using the 4 thumbscrews. If these are lost, you may replace them with metric screws, 4mm thread and 16mm long (M4x16).

Place the Front-Channel Displays

CAUTION! Please read the manufacturer’s manuals for the LCD displays located in the appendix. Locate the three front channel displays on the tabletop behind the instrument panel as shown. Connect the video (DVI) and power cables to each monitor. The center display should be centered directly behind the instrument panel display, Figure 8.

Place the Audio System

Unpack the audio system (Logitech Z-2300). Place the subwoofer under the table, and place the two satellite speakers to the left and right of the instrument panel display, Figure 8. Observe the left and right labels.

Connect the satellite speakers to the appropriate jacks on the rear of the subwoofer. Connect the subwoofer volume control to the subwoofer, Figure 9.

Place the Tactile Transducer

If your simulator has a tactile transducer, first mount it under the desk under or near the steering wheel with self-drilling screws, Figure 10.

The tactile transducer requires a small audio amplifier (Pyle ProPCA3 shown). Connect one speaker output (Left is shown) to the terminals on the tactile transducer. Polarity (+/-) is not important. Note that we are only using the left channel of the amplifier. Use the RCA to 1/8” headphone ‘Y’ cable to connect the audio amplifier to the PC. Connect the White RCA to the Left input jack on the amplifier and plug the 1/8” headphone plug into the Orange audio output on the PC. Not all Y cables are alike, so use the Realtek Audio Manager test tones to check that the subwoofer (not the center) is being used.